INTEC TG is an additive for natural rubbers, nitriles, EPDM, SBR and other commodity grade rubbers.
Composition:
Inorganic polymeric modifier.
Benefits:
- It modifies the rheology under processing conditions to enhance the flow characteristics of a range of organic Elastomers.
- It can modify the compound/ equipment interface, to assist in improved flow and can contribute to improved mold release.
- It can enhance filler dispersion.
- Enhances flow and widens the compound processing window. Additionally, during the demolding phase, the INTEC TG can improve part release.
- For molding, this translates into a reduction in underfills, improvement in knit line strength, improvement in mold release, and sometimes reduction in mold fouling.
With extrusion, this translates into the potential for a higher output (FPM), and/or lower power draw at equal rpm. It can also assist in lowering die drag.
With mixing it can lead to a reduction in cycle time and/or improvement in dispersion providing more consistent batch to batch properties
Properties |
Typical |
Appearance | Dark gray powder |
Odor | None |
Specific Gravity | 4.00 +/- .04 |
Density | 3.98 |
Percent Volatiles | None |
pH | 7.0 |
Storage Stability | Unlimited shelf life |
Packaging:
50 LB Bags, gaylords, and drums (special packaging available).
Addition Levels:
1 – 5 phr
INTEC FLUORO FLOW
is for Fluoroelastomers
Composition:
Inorganic polymeric modifier.
Benefits:
- Reduced “non-fills“ on molding
- Improved mold release
- Better dispersion of fillers and additives
- Improved extrusion rate without affecting dimensional stability
- No loss of physical properties for most compounds
- Non-blooming properties
- Better surface appearance
- Excellent “bin storage”
Properties |
Typical |
Appearance | Dark gray powder |
Odor | None |
Specific Gravity | 4.00 +/- .04 |
Density | 3.98 |
Percent Volatiles | None |
pH | 7.0 |
Storage Stability | Unlimited shelf life |
Packaging:
50 LB Bags, gaylords, and drums (special packaging available)
Addition Levels:
1 – 6 phr